The maintenance compressed air systems are often specified in the system documentation, provided by the manufacturer. In this artical we would like to introduce some rules and maintenance regimes according to general regulation.
The movement of screw is pineaple-sharpened, therefore it's nescessary to use lubricating oil with theaim to reduce the corrosion and softly operate. The bearing is completely stay in air end so it is also lubricated with air compressor oil.
Compressed air system in factory plays an important role. In order to ensure the stable operation during the manufacturing process, the regulary maintenance is nescessary . However, there are many different problems in fact such as: Air compressors, dusty air dryers, high engine room temperatures, unsecured wind convection ... lead to reduce using time of compressor accessories (air filter, oil filter, oil separator ...). On the other hand, the recommended maintenance in some factories is not seriously followed and there are deviations.
The SWAN air compressor CS-1 series are modular in desig reliability, simple maintenance and quiet operation. Using Germany air end and accurate control components, stable quality consistent with the real needs of users.
Each compressor requires well-timed service. Under the service means change the oil, replacement of the oil and air filter, separator, check the belt tension (if it is not the compressor with direct drive), lubrication of the bearings, different type of the valve checking, replacement of the valves if necessary. Also according to the operational manual it is necessary to replace inlet valve repairing kit, minimum pressure valve, thermostat valve and return valve.
